Update February 2, 2023
The shop now has 2 Prusa mk3S printers - Prusa A and Prusa B. Please book them using the corresponding forms below.
Before printing checklist
Your part is printable and supports are enabled (if needed?)
The correct material is loaded. Currently we only support PLA.
The bed is correctly attached.
You scheduled the print time and material usage. Please use this page to register your Prusa prints.
You wiped the bed with IPA just prior to printing.
You will wait for the first layer to start before leaving the shop!
You will set an alarm to pick up your part, and will clean the space after use.
If you would like, please review the training material here.
If you are unsure which printer to use, please consult the 3D printer selection guide.